PathTests.TestPathDrillGenerator.TestPathDrillGenerator Class Reference
Public Member Functions | |
| def | test00 (self) |
| def | test10 (self) |
| def | test20 (self) |
| def | test30 (self) |
| def | test40 (self) |
| def | test41 (self) |
| def | test42 (self) |
 Public Member Functions inherited from PathTests.PathTestUtils.PathTestBase | |
| def | assertArc (self, edge, pt1, pt2, direction="CW") |
| def | assertCircle (self, edge, pt, r) |
| def | assertCoincide (self, pt1, pt2, error=0.0001) |
| def | assertCommandEqual (self, c1, c2) |
| def | assertConeAt (self, solid, pt, r1, r2, h) |
| def | assertCurve (self, edge, p1, p2, p3) |
| def | assertCylinderAt (self, solid, pt, r, h) |
| def | assertEdgeShapesMatch (self, e1, e2) |
| def | assertEqualLocale (self, s1, s2) |
| def | assertLine (self, edge, pt1, pt2) |
| def | assertLines (self, edgs, tail, points) |
| def | assertPlacement (self, p1, p2) |
| def | assertPointsMatch (self, pts0, pts1) |
| def | assertRoughly (self, f1, f2, error=0.00001) |
Member Function Documentation
◆ test00()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test00 | ( | self | ) |
Test Basic Drill Generator Return
Referenced by PathTests.TestPathTool.TestPathTool.test01(), PathTests.TestPathToolController.TestPathToolController.test01(), PathTests.TestPathTooltable.TestPathTooltable.test01(), PathTests.TestPathTool.TestPathTool.test02(), and PathTests.TestPathTooltable.TestPathTooltable.test02().
◆ test10()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test10 | ( | self | ) |
Test edge alignment check
◆ test20()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test20 | ( | self | ) |
Test Basic Peck Drill Generator Return
◆ test30()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test30 | ( | self | ) |
Test Basic Dwell Drill Generator Return
◆ test40()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test40 | ( | self | ) |
Specifying retract height should set R parameter to specified value
◆ test41()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test41 | ( | self | ) |
Not specifying retract height should set R parameter to Z position of start point
◆ test42()
| def PathTests.TestPathDrillGenerator.TestPathDrillGenerator.test42 | ( | self | ) |
Non-float retract height should raise ValueError
The documentation for this class was generated from the following file:
- FreeCAD/src/Mod/Path/PathTests/TestPathDrillGenerator.py
